Digital Monitoring Products Canadain XR500 Podręcznik Użytkownika Pobierz pdf (Strona 43)

System Link User’s Guide 33

In keypad mode, the account number reported to the receiver originates from the panel

attached to the iCOMsl. The account number entered here, when in keypad mode, is used

for programming with System Link only. The iCOM

SL and the panel have separate account

numbers.

When you are finish entering data into the fields in the New Panel window click OK to

close that window and go back to the Panel Information window. Click once on the line

with the panel that you just entered in the New Panel window.

Note: When assigning account numbers, keep the following conventions in mind.

When using DD (Digital Dialer) Communication, the range of available account numbers is

1 through 65535.

When using Modem IIe, Contact ID, or 4-2 communication, select an account number

between 1 and 9999.

When using Host/Net mode, the range of available account numbers is 1 and 65535.

When using Multiplex (MPX) communication, you must select a 5-digit account number.

The first number is the receiver line number, which is usually 1. The second number is

always 0. Assign three digits, between 000 and 127, as the main panel account number.

The full account number should read between 10000 and 10127. If you wish to assign

separate account numbers to individual areas, assign an area account number between 128

and 999. The final account number for areas should read between 10128 and 10999.

Entering the Account Details

You may enter account details, such as the site location and phone number, in the Panel

Information window.

General Information

In the Panel Information window, enter the rest of the information about your new panel

account by filling in the fields on the right side of the window. Enter a name for the

account in the Name field, and assign an account number in the General Information

section.

Connection Information

Type

: From the Type menu select which type of connection you wish to use to

communicate with the panel:

•

SCS-1

SCS-105

: Select this option if

System Link is going to communicate with

the panel through an SCS-1, SCS-1R or SCS-

105 Receiver using a dial-up connection.

•

Network

: System Link is going to

communicate with the panel through a data network connection. Depending on the

panel, connect to the network through:

— The XR500N/XR500E/XR2500F/XR100N panel on-board Ethernet.

— A 462N card and an iCOM™ Network Alarm Router or iCOM-E™ Encrypted Network

Alarm Router.

— An XRSuper6/XR20/XR40 panel and an iCOM

SL Network Alarm Router.

— An XT30/XT50 panel with on-board Ethernet.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 103 104

Komentarze do niniejszej Instrukcji

Brak uwag

Digital Monitoring Products Canadain XR500 Podręcznik Użytkownika Strona 43

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Digital Monitoring Products Canadain XR500