
Digital Monitoring Products XR500 Series Programming Guide
60
Feature upgrade
Feature Upgrade
22.1
FEATURE UPGRADE
Feature Upgrade
In the Programming Menu, pressing COMMAND at the SET LOCKOUT CODE option displays
FEATURE UPGRADE. This allows you to enable additional features in the panel. Press any
top row Select key to display the rst available feature. ENABLED or DISABLED displays
indicating whether this feature is currently used in this panel. Press the COMMAND key to
display additional feature(s).
ENTER KEY
-
To enable a feature, press any top row Select key anywhere in the features list to display
the ENTER KEY option.
Enter the factory-supplied feature key for the specic panel and press the COMMAND key.
The feature specic to the key displays as ENABLED.
Note: XR500 Series version 106 or higher panels require a six (6) character feature key.
Version 105 panels require a 16-character feature key.
If the feature key entered is not accepted, the ENTER KEY option displays again. Re-enter
the feature key and press the COMMAND key.
22.1.1
ENCRYPTION
DISABLED
Encryption
Enable this feature to provide 128 bit AES data encryption. This feature upgrade can only
be enabled on an XR500N panel version 105 or higher. For installations where an XR500
panel is installed, it is recommended the XR500 be replaced with an XR500E panel.
To complete encryption installation, access System Status in the User Menu to verify the
encryption status (ON or OFF). If the status displays OFF, it indicates that the Passphrase
has not been entered and data transmissions are not encrypted. See Network Options to
set up a Passphrase.
22.1.2
ALL NO YES OPTN
DISABLED
All No Yes Option
This feature offers the ability to disable the ALL NO YES option at arming or disarming.
When this feature is enabled, the ALL NO YES option does not display at any system
keypad during arming or disarming. Each area assigned to the user prole is chosen to be
armed or disarmed independently.
22.1.3
SVC USER AUTH
DISABLED
Service User Authentication
This feature offers the ability to authenticate service personnel before allowing access
to panel programming or performing any user operations. When this feature is enabled
and a valid Service User code is entered for system operation or 6653 is entered for
programming, the Service Code entry option displays.
When the service person enters the Service Code, the panel authenticates the code
with the Service Code preprogrammed in the SCS-1R receiver, and access to panel
programming or the User Menu is granted. The Service Code can be used for system
operation for 30 minutes before authenticating again. If the code entered is not
validated, access to programming or the User Menu using the Service User code is denied.
Note: The Service User code is user number zero (0) and can only be created in the panel
remotely. The SCS-1R receiver must have rmware version 902 or higher to authenticate
service personnel.
Purchasing Feature Upgrades
To purchase a feature upgrade, you may contact DMP Customer Service with the feature
you would like to enable and the panel serial number. The serial number(s) should be
sent in writing via e-mail or fax. A separate feature key is issued for each panel. The
feature key only enables the requested feature on the specied panel.
The panel serial number can be located several different ways:
• Printed on a label located on the right side of the XR500 PCB.
• Using panel diagnostics. See the Appendix.
• Using Remote Link™ (version 1.18 or greater). See the Remote Link User’s Guide
(LT-0565).
— Initial Panel Connection screen
— System Information screen.
Komentarze do niniejszej Instrukcji