Digital Monitoring Products 1912XR Przewodnik Instalacji Pobierz pdf (Strona 18)

Digital Monitoring Products, Inc.

1912XR Programming

Page 12

5.1 This section allows you to enter the information needed for Remote Command/

Remote Programming operation.

A description of the Remote Options follow:

5.2 REMOTE KEY - This option allows you to enter a code of up to eight digits for

use in verifying the authority of an alarm or service receiver to perform a remote

command/programming session. The receiver must give the correct key to the

panel before being allowed any remote functions. All panels are shipped from the

factory with the key preset as blank.

To enter a remote key or change the current one, press a top row SELECT key

and enter any combination of up to eight digits. Press COMMAND. The current

key is never displayed.

5.3 MANUFACTURER AUTHORIZATION - Enter YES to allow DMP service

technicians to access the panel when required during system service or

troubleshooting. This authorization automatically expires within one hour.

DMP remote service is provided on a read only basis:

DMP technicians can look at the system

programming and make suggestions only. Alterations can only be accomplished by the installing

company's service personnel.

5.4 ARMED RINGS - Enter the number of rings the panel counts before answering

the phone line when all areas of the system are armed. Any number from 1 to 15

can be entered. If zero is entered, the panel does not answer the phone when all

areas of the system are armed.

5.5 DISARMED RINGS - Enter the number of rings the panel counts before

answering the phone line while any areas of the system are disarmed. Any

number from 1 to 15 can be entered. If zero is entered, the panel does not

answer the phone when any area of the system is disarmed.

5.6 ALARM RECEIVER AUTHORIZATION - Enter YES to enable remote

commands and programming to be accepted from the alarm SCS-1 Receiver.

The Remote Key option can also be required.

With YES selected, the panel requests the receiver key during its first

communication with the first SCS-1 receiver. The panel retains this alarm

receiver key in memory and allows remote commands to be accepted from the

alarm receiver. If an alarm occurs during a remote connect, the alarm report is

immediately sent to this receiver only.

When NO is selected, remote commands and programming are not accepted

from the alarm SCS-1 Receiver.

ALR RCVR NO

RMT KEY:

DISARM RINGS: 0

MFG AUTH NO

5-REMOTE OPTIONS

ARM RINGS: 0

REMOTE OPTIONS

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 41 42

Komentarze do niniejszej Instrukcji

Brak uwag

Digital Monitoring Products 1912XR Przewodnik Instalacji Strona 18

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Digital Monitoring Products 1912XR