Digital Monitoring Products Canadain XR500 Przewodnik Instalacji Pobierz pdf (Strona 7)

XR500 Series Canadian Installation Guide Digital Monitoring Products

IntroductIon

Product Specications

1.1 Power Supply

Transformer Input: Model 327-CAN, plug-in — Primary input: 120 Vac, 60 Hz, Secondary output: 16.5 Vac 50 VA

Model FTA7516 ATC Frost from Standex Electronics — Primary input: 120 Vac, 60 Hz,

Secondary output: 16 Vac 75 VA

Standby Battery: 12 Vdc, 1.0 Amps Max. charging current

Models 365, 366, 368, or 369

Replace every 3 to 5 years

Auxiliary: 12 Vdc output at 1.0 Amp Max using Model 327-CAN

Bell Output: 12 Vdc at 1.0 Amp Max using Model 327-CAN

Auxiliary: 12 Vdc output at 1.5 Amp Max using Model FTA7516

Bell Output: 12 Vdc at 1.5 Amp Max using Model FTA7516

All circuits are inherent Power Limited except the red battery wire and AC terminal.

1.2 Communication

•Built-in network communication to DMP Model SCS-1R or SCS-VR Receivers (XR500N/XR500E only)

•Built-in encrypted communication to DMP Model SCS-1R Receivers (XR500E only)

•Built-in dialer communication to DMP Model SCS-1R Receivers

•Optional cellular communication to DMP Model SCS-1R or SCS-VR Receivers

•Built-in Contact ID communication to DMP Model SCS-1R Receivers

•Optional 893A Dual Phone Line Module with phone line supervision

•Can operate as a local panel

1.3 Panel Zones

Eight 1k Ohm EOL burglary zones (zones 1 to 8)

Two 3.3k Ohm EOL powered zone with reset (zones 9 and 10)

1.4 Keypad Bus

You can connect up to a total of 16 of the following supervised keypads and expansion modules to the keypad bus:

• Alphanumerickeypads • Four-and/orsingle-zoneexpansionmodules

• Single-zonedetectors • Accesscontrolmodules

• WirelessKeypads(maximumof4)

1.5 LX-Bus™

YoucanconnectthefollowingdevicestotheLX-Bus™providedonthepanelorbytheDMP481,462N,and464-263H

InterfaceCardsuptothemaximumnumberofLX-Bus™addresses.SeeAccessoryDevicesinsection3.4.

• Sixteen-,eight-,four-and/orsingle-zoneexpansionmodules • Graphicannunciatormodules

• Model521LXor521LXTSmokeDetectorswithCleanMe • Relayoutputexpansionmodules

• Model2W-BLXor2WT-BLXSmokeDetectors

1.6 Outputs

The XR500 Series provide two Single Pole, Double Throw (SPDT) relay outputs which require the installation of two

Model305relays,eachrated1Ampat30Vdcresistive(powerlimitedsourcesonly).AModel431OutputHarnessis

required to use these outputs.

The XR500 Series panels also provide four open collector outputs rated for 50mA each. The open collector outputs

provide ground connection for a positive voltage source. A Model 300 Output Harness is required to use these

outputs.

1.7 Enclosure Specications

The XR500 Series panels are shipped in an enclosure with a transformer, End-of-Line resistors, battery leads, user’s

guide, and programming sheets.

Enclosure

Model

Size Color(s) Construction (Cold Rolled

Steel)

350 17.5”W x 13.5”H x 3.5”D Gray (G) or Red (R) 18-Gauge

350A 17.5”W x 13.5”H x 3.75”D Gray (G) 18-Gauge with 16-Gauge door

341 12.75”W x 6.55”H x 3.15”D Gray (G) 20-Gauge

352X 14.5”W x 32.0”H x 4.0”D Gray (G) 16-Gauge

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Komentarze do niniejszej Instrukcji

Brak uwag

Digital Monitoring Products Canadain XR500 Przewodnik Instalacji Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Digital Monitoring Products Canadain XR500